How to Set Up the IVG Pro 12 in 3 Easy Steps?

You just bought an IVG Pro 12 and now you want to start vaping. That makes sense, but if you skip the setup steps, you will get a burnt taste and waste your money. 

Do not let that happen. In fact, the good news is that setting up this kit takes less than one minute, literally. You do not even need any tools or special skills. 

This blog walks you through three simple steps that work every time. Follow along and you will enjoy clean flavour from the very first puff all the way to puff number ten thousand. Let us get started.

What You Get in the Box?

• IVG Pro 12 battery

• prefilled 2ml pod

• separate 10ml refill container

• user guide

There is no charging cable included.

Step One: Connect the Pod and Refill Container

This is where most people make mistakes. The IVG Pro 12 10000 box of 5 comes with two separate pieces that must click together. Take the small 2ml pod in one hand and the larger 10ml refill container in the other hand. Look at the bottom of the small pod and the top of the large container. You will see they are shaped to fit together. Press them firmly until you hear a distinct click sound. 

That click means they are locked properly. Do not just push gently, use enough force to feel the connection snap into place. If you do not hear a click, pull them apart and try again. A loose connection causes leaks and bad airflow. Once clicked together, you have one complete pod unit ready to go.

Setting Up in Ireland

When vaping in Ireland, chances are that the weather is cold and wet. Cold causes the e-liquid to be thicker and slower to trickle into the coil, and thus you have to wait longer when you set it up. In Dublin, Cork, or Galway, give the pod about fifteen minutes instead of five. Keep the IVG Pro 12 In Ireland in your jacket pocket or near a warm place so the liquid flows better.

Also, vapers in Ireland often pay more for single-use vapes, so the IVG Pro 12 In Ireland is a better choice. You get twelve thousand puffs from one pod set, which means fewer trips to the shop. Follow the same step one, but add extra patience before your first puff. The cold air outside will not hurt the vape once it is set up correctly, just store it upright when not in use.

Step Two: Insert the Pod Unit into the Battery

Now, take the connected pod unit you just made and look at the top of the battery vape. You will see an opening shaped exactly like the bottom of your pod. Slide the pod straight down into that opening; do not force it at an angle. Straight down only and press until the pod sits flush with the battery body. You should feel it settle into place. 

There is no button to push or lock to turn. The pod stays in using magnets or a snug fit, depending on your model. Give it a gentle tug to make sure it does not come out easily. If it feels loose, take it out and reinsert it. A secure connection matters for the auto-draw system to work right. Once the pod is in, do not vape yet, wait.

Setting Up in Scotland

Scottish vapers from Glasgow to Edinburgh to the Highlands deal with similar cold weather issues as Ireland but there is another factor. Hard water areas mean more limescale buildup on charging ports if you are not careful. Keep your USB-C port clean and dry. When setting up your IVG Pro 12 in Scotland, pay extra attention to the click sound in step one. The pod and container can feel stiff in colder rooms. 

Warm them in your hands for a minute before pressing them together. Scottish vapers also tend to prefer menthol and mint flavours due to the fresh air association. That works well because ice flavours perform great in this kit. After you insert the pod, find a warm spot away from drafty windows. Let it sit for ten minutes minimum. Rushing this step ruins the coil and wastes your money.

Step Three: Wait and Then Vape

This step is the hardest because you just want to Vape Wholesale but do not skip it. The new coil inside the pod is completely dry. If you vape right away, the cotton burns instantly. That burnt taste never goes away, so you must wait five to ten minutes after inserting the pod. This waiting period lets the e-liquid soak into the mesh coil. 

After the wait, lift the vape to your mouth and take a slow, gentle inhale. Do not pull hard like a cigarette, in fact, a slow three-second draw works best. The auto-draw sensor activates and you will hear a soft crackle. That is the mesh coil heating properly. Exhale and enjoy a clean flavour. If the first puff tastes dry or strange, wait another two minutes and try again.

Setting Up in the Midlands

How to Know You Did It Right?

A correct setup gives you three signs. First, the draw feels smooth with no gurgling sounds. Second, the flavour tastes clean and matches the description on the box. The vapour stays the same with each puff. If it tastes burnt, you did not wait long enough. 

No vapour indicates the pod has not been fitted correctly and a gurgling noise indicates excess liquid. Repair it by removing the pod, blowing through the mouthpiece into a tissue and replacing. Most issues happen from rushing, so slow down and it will work fine.

Charging Your IVG Pro 12 Properly

After setup, you will eventually need to charge. Use any USB-C cable but avoid cheap ones from petrol stations. Plug the cable into the bottom port of the vape. The LED display shows battery percentage. Charge until it reaches one hundred percent. 

Also, never ever charge overnight or while vaping. Keep the port clean using a dry toothpick or compressed air. A full charge takes about sixty to ninety minutes and lasts for days, depending on your usage

Conclusion

Setting up your IVG Pro 12 Box of 5 takes less than a minute and saves you from that horrible burnt taste. Just click the small pod into the large refill container and slide the unit into the battery.

Then wait five to ten minutes before your first puff. That waiting step matters most, if you skip it, you will ruin the coil. Follow it and you get a clean flavour for all ten thousand puffs. 

Vapers in Ireland and Scotland need extra waiting time due to the cold. Midlands vapers can stick to five minutes. No tools, no skills, no stress. Now go enjoy your vape the right way.